Up 0 Down Cancel. Dear Sachin, Thanks for the info. Hi Steve, It seems, the policies are matching now. Are you able to establish the IPSec Tunnel?
Cheers Sachin. Dear Sachin, I tried to set both life time to be But it still not working. Unfortunately, the problem couldn't be resolved in over 2 months. Contents Introduction. Prerequisites Requirements Cisco recommends that these requirements be met before you attempt the configuration that is described in this document: The end-to-end IP connectivity must be established.
Configure the peer IP address. In this example, the peer IP address is set to If you configure the peer IP address on Site A, it must be changed to The interface through which the remote end can be reached is also specified.
Click Next once complete. Configure the local and remote networks traffic source and destination. This image shows the configuration for Site B the reverse applies for Site A : On the Security page, configure the pre-shared key it must match on both of the ends. Configure the source interface for the traffic on the ASA. The wizard now provides a summary of the configuration that will be pushed to the ASA.
Review and verify the configuration settings, and then click Finish. The 1 in the above command refers to the Policy suite priority 1 highest, lowest authentication pre-share encryption aes hash sha group 2 lifetime Create a tunnel group under the IPsec attributes and configure the peer IP address and the tunnel pre-shared key: tunnel-group Note the IKEv1 keyword at the beginning of the pre-shared-key command.
Phase 2 IPsec Complete these steps for the Phase 2 configuration: Create an access list that defines the traffic to be encrypted and tunneled. In this example, the traffic of interest is the traffic from the tunnel that is sourced from the George Mavimbela Posted August 12, 0 Comments. Anonymous Posted August 12, 0 Comments. Anonymous Posted August 13, 0 Comments. Dear, What is the code you are running and I guess your memory may MB.
And Mbps VPN throughput. So you should be ok. Register or Login. Welcome back! Reset Your Password We'll send an email with a link to reset your password. Stay ahead! Get the latest news, expert insights and market research, tailored to your interests. Sign in with email Enter the email address associated with your account. You auth link is expired or incorrect, please try again. Sign up with email Get the latest news, expert insights and market research, tailored to your interests.
The Meraki is a MX that is brand new and being setup for the first time. Phase 1 is establishing but it appears it is not even attempting Phase 2 so while it is showing up no traffic is passing. I have the same subnets on both sides. Contacted support but they are trying to blame the subnets even though they are the same on each side. Any help or thoughts would be appreciated. I have had issues with Meraki and ASA since I implemented it back in October, I have a ticket opened with them since October too and today we still have to reset the tunnel in the ASA side every now and then random as we don't know what's going on and it is really frustrating.
I have tested everything and next step is going to be removing the MX if no fix is provided within a couple of weeks we have another ASA in the same location as Meraki working perfectly. We seem to have had Zach 's question hi-jacked nicely and now have two separate issues in the one thread.
Back to Zach 's issue. The current "gold star" release is asak8. Is it possible to upgrade the ASA to this "gold star" release?
0コメント